Mazda 6 manuals

Mazda 6 Service Manual: General procedures

Mazda 6 Service Manual / Steering system / General procedures

Wheels and Tires Removal/Installation

The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}.

Power Steering Components Removal/Installation

If any power steering fluid line has been disconnected anytime during the procedure, add ATF M-III

or equivalent (e.g. Dexron®II

), bleed the fluid lines, and inspect for leakage after the procedure has been completed.

Connectors Disconnection/Connection

Disconnect the negative battery cable before doing any work that requires handling of connectors. Reconnect the negative battery cable only after the work is completed.

Suspension Arm Removal/Installation

Tighten any part of the suspension that uses rubber bushings only after vehicle has been lowered and unloaded.

Note

 

Location index
STEERING LOCATION INDEX ...

Engine speed sensing power steering
...

Other materials:

Mazda 6 Service Manual: Caliper (front) disassembly/assembly
1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of removal. Piston Disassembly Note Caution Blow the compressed air slowly to prevent the piston from suddenly popping out. 1. Place a piece of wood in the caliper, then blow compressed air through ...

Mazda 6 Service Manual: Turning the Engine Off
WARNINGDo not stop the engine while the vehicle is moving: Stopping the engine while the vehicle is moving for any reason other than in an emergency is dangerous. Stopping the engine while the vehicle is moving will result in reduced braking ability due to the loss of power braking, which coul ...

© 2016-2026 Copyright www.mazda6info.net