Mazda 6 Owners Manual: Pre-programming the HomeLink System
NOTE
It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink for quicker training and accurate transmission of the radio-frequency signal.
- Verify that there is a remote control transmitter available for the device you would like to program.
- Disconnect the power to the device.
HomeLink Wireless Control System (Some models)
NOTE
HomeLink and HomeLink house icon are registered trademarks of Gentex Corporation.
The HomeLink system replaces up to 3 hand-held transmitters with a single built-in
component in the auto-dimm ...
Programming the HomeLink System
CAUTION
When programming a garage door opener or a gate, disconnect the power to these
devices before performing programming. Continuous operation of the devices could
damage the motor.
The Home ...
Other materials:
Mazda 6 Owners Manual: Engine Coolant Temperature Gauge
Displays the engine coolant temperature. The blue gauge indicates that the engine
coolant temperature is low, and the red gauge indicates that the engine coolant
temperature is high and overheating.
CAUTION
If the high engine coolant temperature warning light (red) turns on, there
is a pos ...
Mazda 6 Owners Manual: Climate control unit removal
1. Disconnect the negative battery cable.
2. Disconnect the air mix and airflow mode wires from each wire clamp and
link. (Manual air conditioner)
3. Remove the center panel. (See CENTER PANEL MODULE REMOVAL/INSTALLATION.)
4. Remove the screws and climate control unit. (Full-auto air conditione ...