Mazda 6 Service Manual: Rear antenna feeder inspection
1. Verify that there is no continuity between antenna feeder terminals A and B using an ohmmeter.
2. Inspect for continuity between the antenna feeder terminals using an ohmmeter.
- If not as specified, replace the rear harness.
Front antenna feeder inspection
1. Verify that there is no continuity between the front antenna feeder
terminals A and B using an ohmmeter.
2. Inspect for continuity between the front antenna feeder terminals using an
ohmme ...
Other materials:
Mazda 6 Service Manual: Main fuse removal/installation
1. Disconnect the negative battery cable.
2. Remove the main fuse block cover.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Bolt Removal Note
1. Press and remove the tabs on the main fuse block at the positions
indicated by the arrows.
2. L ...
Mazda 6 Service Manual: Removal/Installation
To remove the head restraint, pull it up while pressing the stop-catch.
To install the head restraint, insert the legs into the holes while pressing
the stop-catch.
WARNING
Always drive with the head restraints installed when seats are being used
and make sure they are properly installed: Dri ...