REAR OIL SEAL REPLACEMENT
1. Remove the flywheel. (MTX) (See CLUTCH UNIT REMOVAL/INSTALLATION)
2. Remove the drive plate. (ATX) (See DRIVE PLATE REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Rear Oil Seal Installation Note
1. Apply silicone sealant to the mating faces as shown.
Dot diameter:
4.0-6.0 mm {0.16-0.23 in}
2. Apply clean engine oil to the new oil seal lip.
3. Install the rear oil seal using the installer as shown.
4. Tighten the rear oil seal bolts in the order as shown.
Tightening torque: 8.0-11.5 N·m {81.6-117.2 kgf·m, 70.9-101.7 in·lbf}
Mazda 6 Service Manual: Magnetic clutch disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
3. Adjust the magnetic clutch clearance. (See MAGNETIC CLUTCH ADJUSTMENT.)
Bolt Removal/Installation Note
1. When removing or installing the bolt, hold the pressure plate in place as
shown ...
Mazda 6 Service Manual: Hold switch inspection
Operating Inspection
1. Turn the ignition switch to ON (engine OFF).
2. Verify that the HOLD indicator light is not illuminated. Depress the HOLD
switch and verify that the HOLD indicator light illuminates.
If not as specified, inspect the terminal voltage of the HOLD switch.
Voltage Insp ...