Mazda 6 Owners Manual: Reprogramming the HomeLink system
To program a device to HomeLink using a HomeLink button previously trained, follow these steps:
1. Press and hold the desired HomeLink button. DO NOT
release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink button, proceed with “Programming” - step 1.
Operating the HomeLink System
Press the programmed HomeLink button to operate a programmed device. The code
will continue being transmitted for a maximum of 20 seconds. ...
Erasing Programmed HomeLink Buttons
To erase the existing programming from all three operating channels, press and
hold the two outside buttons ( ,
) on the auto-dimming mirror until the HomeLink
indicator light begins to flash aft ...
Other materials:
Mazda 6 Owners Manual: Rear door trim removal/installation
1. Disconnect the negative battery cable if equipped with power window
system.
2. Remove the regulator handle if equipped.
3. Open the cap using a small screwdriver, then remove the screw.
4. Remove the inner handle cover.
5. Remove the cover, then remove screw.
6. Disengage clips A from th ...
Mazda 6 Owners Manual: To Resume Cruising Speed at More Than 25 km/h (16 mph)
If some other method besides the OFF/ CANCEL switch was used to cancel cruising
speed (such as applying the brake pedal) and the system is still activated, the
most recent set speed will automatically resume when the RESUME/
switch is pressed.
If vehicle speed is below 25 km/h (16 mph), incre ...