Mazda 6 Service Manual: Sas unit configuration
1. Connect the SST
(WDS or equivalent) to the DLC-2.
2. Input vehicle information following the directions on the screen.
3. Select Module programming.
4. Select Programmable module installation.
5. Select the following items and perform procedures according to directions on the screen.
Items
- RCM
6. Retrieve DTCs by the SST
(WDS or equivalent), then verify that there is no DTC present.
- If DTC is present, perform applicable DTC inspection.
Sas unit removal/installation
Warning
Handling the SAS unit improperly can accidentally deploy the air
bag modules and pre-tensioner seat belt, which may seriously injure you.
Read AIR BAG SYSTEM SERVICE WARNINGS before ...
Clock spring removal/installation
1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE
REMOVAL/INSTALLATION.)
3. Remove the steering wheel. (See STEERING WHEEL AND COL ...
Other materials:
Mazda 6 Service Manual: Temporary Spare Tire
Inspect the temporary spare tire at least monthly to make sure it is properly
inflated and stored.
NOTE
The temporary spare tire condition gradually deteriorates even if it has not
been used.
The temporary spare tire is easier to handle because of its construction which
is lighter and small ...
Mazda 6 Service Manual: Panel Maintenance
If a panel becomes soiled, wipe it off with a soft cloth soaked in clean water
and thoroughly wrung out.
If some areas require further cleaning, use the following procedure:
1. Wipe the soiled area with a soft cloth soaked in a mild detergent (approx.
5 %) diluted with water.
2. Wipe off the ...