Mazda 6 Owners Manual: Supplemental Restraint System Components
(With Front Passenger Occupant Classification System)
(Without Front Passenger Occupant Classification System)
- Driver/Front passenger inflators and air bags
- Roll-over sensor (some models), crash sensors, and diagnostic module (SAS unit).
- Seat belt pretensioners
- Front air bag sensors
- Side crash sensors
- Air bag/seat belt pretensioner system warning light
- Side and curtain inflators and air bags
- Front passenger air bag deactivation indicator light (some models)
- Front passenger occupant classification sensor (some models)
- Front passenger occupant classification module (some models)
Supplemental Restraint System (SRS) Precautions
The front and side supplemental restraint systems (SRS) include different types
of air bags. Please verify the different types of air bags which are equipped
on your vehicle by locating the “SRS ...
How the SRS Air Bags Work
Your Mazda is equipped with the following types of SRS air bags. SRS air bags
are designed to work together with the seat belts to help to reduce injuries during
an accident.
The SRS air bags are ...
Other materials:
Mazda 6 Owners Manual: Schedule 1
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if
necessary.
R: Replace
L: Lubricate
T: Tighten
Remarks:
*1 Use of FL-22 is recommended when replacing engine coolant. Using engine coolant
other than FL-22 may cause serious damage to the engine and cooli ...
Mazda 6 Owners Manual: Rear washer hose removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Partially peel off the right side mud guard.
4. Remove rear washer hose No.1 from the clips.
5. Remove rear washer hose No.1 and joint pipe A.
6. Remove the A-pillar trim. (See A-PIL ...