Operating Inspection
1. Verify that the starter operates only when the ignition switch is at the START position with the selector lever in P or N position.
2. Verify that the back-up lights illuminate when shifted to R position with the ignition switch at the ON position.
Continuity Inspection
Caution
1. Disconnect the negative battery cable.
2. Remove the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
3. Disconnect the TR switch connector.
4. Inspect for continuity at the TR switch.
5. Reinspect for continuity at TR switch.
6. Connect the TR switch connector.
7. Install the air cleaner component. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
8. Connect the negative battery cable.
Mazda 6 Service Manual: Power window motor removal/installation
1. Disconnect the negative battery cable.
2. Remove the front door trim or rear door trim.
3. Disconnect the power window motor connector.
4. Remove the bolts.
5. Remove the power window motor from the power window regulator drum.
6. Install in the reverse order of removal.
Note
When ins ...
Mazda 6 Service Manual: Rear crossmember removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...