Mazda 6 Service Manual: Air bag system

Cruise control system

Power system

Other materials:

Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to bypass a switch. Caution Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to wiring harnesse ...

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...