Mazda 6 Service Manual: Arrangement of parts

Mazda 6 Service Manual / General information / Fundamental procedures / Arrangement of parts

All disassembled parts should be carefully arranged for reassembly.
Be sure to separate or otherwise identify the parts to be replaced from those that will be reused.

Inspection during removal, disassembly

When removed, each part should be carefully inspected for malfunction, deformation, damage, and other problems. ...

Cleaning of parts

All parts to be reused should be carefully and thoroughly cleaned in the appropriate method. Warning Using compressed air can cause dirt and other particles to fly out causing injury t ...

Other materials:

Mazda 6 Service Manual: Rear crossmember removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm system inspection
System Inspection Preparation 1. Verify that the battery is fully charged. With the ignition switch on, verify that the ABS and BRAKE system warning lights goes out after 2.4 seconds. 2. If the lights stays on after 2.4 seconds, the ABS (ABS/TCS) HU/CM detects a failure. Follow the troubles ...