Mazda 6 Service Manual: Fundamental procedures
Mazda 6 Service Manual / General information / Fundamental procedures
- Protection of vehicle
- Preparation of tools and measuring equipment
- Special service tools
- Oil leakage inspection
- Disconnection of the negative battery cable
- Removal of parts
- Disassembly
- Inspection during removal, disassembly
- Arrangement of parts
- Cleaning of parts
- Reassembly
- Adjustment
- Rubber parts and tubing
- Hose clamps
- Torque formulas
- Vise
- Dynamometer
- Sst
Units
Conversion to SI Units (Système International d'Unités)
All numerical values in this manual are based on SI units. Numbers shown
in conventional units are converted from these values.
Ro ...
Protection of vehicle
Always be sure to cover fenders, seats and floor areas before starting
work.
...
Other materials:
Mazda 6 Service Manual: Oil pressure inspection
Warning
Continuous exposure to USED engine oil has caused skin cancer in
laboratory mice. Protect your skin by washing with soap and water
immediately after working with engine oil.
Hot engines and engine oil can cause severe burns. Turn off the
engine and wait until it and the engine ...
Mazda 6 Service Manual: Auto leveling control unit configuration
1. Connect the SST (WDS or equivalent) to the DLC-2.
2. Input vehicle information following the directions on the screen.
3. Select Module programming.
4. Select Programmable module installation.
5. When performing configuration corresponding to each auto leveling control
unit, select the fo ...
© 2016-2026 Copyright www.mazda6info.net