Mazda 6 manuals

Mazda 6 Service Manual: Reassembly


- Oil seals

- Gaskets

- O-rings

- Lockwashers

- Cotter pins

- Nylon nuts

- Sealant and gaskets, or both, should be applied to specified locations. When sealant is applied, parts should be installed before sealant hardens to prevent leakage.

- Oil should be applied to the moving components of parts.

- Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.


Cleaning of parts
All parts to be reused should be carefully and thoroughly cleaned in the appropriate method. Warning Using compressed air can cause dirt and other particles to fly out causing injury t ...

Adjustment
Use suitable gauges and/or testers when making adjustments. ...

Other materials:

Mazda 6 Service Manual: Rear brake (disc) removal/installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, depress the pedal several times, rotate the wheel by hand, and verify that the brake does not drag. Disc Pad Installation Note 1. Turn the manual adjustment gear counterclockwi ...

Mazda 6 Service Manual: Front door glass removal/installation
1. Operate the front door glass so that the distance from the top of the front door glass to the upper part of the rear beltline molding is 210 mm {8.3 in}. 2. Disconnect the negative battery cable. 3. Remove the front door trim. 4. Remove the hole cover. 5. Remove the screws. 6. Insert ...

© 2016-2026 Copyright www.mazda6info.net