Mazda 6 manuals

Mazda 6 Service Manual: Removal of parts


Disconnection of the negative battery cable
Before beginning any work, turn the ignition switch to LOCK position, then disconnect the negative battery cable and wait for more than 1 minute to allow the backup power supply of the SAS un ...

Disassembly
If the disassembly procedure is complex, requiring many parts to be disassembled, all parts should be marked in a place that will not affect their performance or external appearance and ident ...

Other materials:

Mazda 6 Service Manual: Spark plug removal/installation
1. Disconnect the negative battery cable. 2. Remove the plug hoie plate. Lift off and remove the plug hole plate from the installation areas (rubber and clips) as shown in the figure. 3. Disconnect the high-tension lead. 4. Remove the spark plugs using the plug-wrench. 5. Install th ...

Mazda 6 Service Manual: Dsc hu/cm inspection
1. Remove the battery and battery bracket. 2. Disconnect the DSC HU/CM connector. 3. Connect the SST (49 G066 004) to the DSC HU/CM connector and harness side connector. 4. Inspect voltage referring the table below. Terminal Voltage Table (reference value) (Ignition switch is at ON, and conne ...

© 2016-2026 Copyright www.mazda6info.net