Mazda 6 Service Manual: Disassembly

Mazda 6 Service Manual / General information / Fundamental procedures / Disassembly

If the disassembly procedure is complex, requiring many parts to be disassembled, all parts should be marked in a place that will not affect their performance or external appearance and identified so that reassembly can be performed easily and efficiently.

Removal of parts

While correcting a problem, also try to determine its cause. Begin work only after first learning which parts and subassemblies must be removed and disassembled for replacement or repair. Aft ...

Inspection during removal, disassembly

When removed, each part should be carefully inspected for malfunction, deformation, damage, and other problems. ...

Other materials:

Mazda 6 Service Manual: A/c compressor removal/installation
1. Disconnect the negative battery cable. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Remove the right side splash shield and mudguard (L.H.D. only). 4. Loosen the drive belt and remove it. Caution If moisture or foreign material enters the refrigeration ...

Mazda 6 Service Manual: Center roof antenna removal/installation
1. Disconnect the negative battery cable. 2. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.) 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 5. After installation, verify that the rubber of the center roof antenna is installed to the r ...