Mazda 6 Service Manual: Preparation of tools and measuring equipment

Mazda 6 Service Manual / General information / Fundamental procedures / Preparation of tools and measuring equipment

Be sure that all necessary tools and measuring equipment are available before starting any work.

Protection of vehicle

Always be sure to cover fenders, seats and floor areas before starting work. ...

Special service tools

Use special service tools or equivalent when they are required. ...

Other materials:

Mazda 6 Service Manual: Tire Pressure Monitoring System Initialization
In the following cases, system initialization must be performed so that the system operates normally. A tire pressure is adjusted. Tire rotation is performed. A tire or wheel is replaced. The battery is replaced or completely drained. The tire pressure monitoring system warning light i ...

Mazda 6 Service Manual: On-board diagnostic test
DTCs Reading Procedure 1. Perform the necessary vehicle preparation and visual inspection. 2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure. 3. Retrieve DTCs by WDS or equivalent. Pending Trouble Code Access Procedure 1. Perform the necessary ...