Mazda 6 manuals

Mazda 6 Service Manual: Sst

Example (section ST)


Example (except section ST)


Dynamometer
When inspecting and servicing the power train on the dynamometer or speed meter tester, pay attention to the following: - Place a fan, preferably a vehicle-speed proportional type, in fron ...

Installation of radio system
If a radio system is installed improperly or if a high-powered type is used, the CIS and other systems may be affected. When the vehicle is to be equipped with a radio, observe the following preca ...

Other materials:

Mazda 6 Service Manual: Egr valve removal/installation
1. Disconnect the negative battery cable. 2. Disconnect the EGR valve connector. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Water Hose Removal Note Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.) EGR Valve Removal Note 1. Re ...

Mazda 6 Service Manual: No.1 while vehicle is in reverse, vehicle locator mark goes forward
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiri ...

© 2016-2026 Copyright www.mazda6info.net