Mazda 6 Service Manual: Rear seat removal/installation
4SD
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
5HB
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Remote wire removal note
1. Turn over the trunk floor mat.
2. Remove the case.
3. Remove the remote wire.
Rear seat removal note
1. Remove the front hinge installation bolts.
2. Lift the rear seat cushion, then remove the rear hinge installation bolts.
Front seat disassembly/assembly
Warning
Handling the front seat (side air bag) improperly can accidentally
deploy the side air bag, which may seriously injure you. Read AIR BAG SYSTEM
SERVICE WARNINGS before handling the f ...
Rear seat disassembly/assembly
4SD
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
5HB
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse o ...
Other materials:
Mazda 6 Service Manual: No.8 brake system warning light stays on more than 4 seconds with ignition
switch on
Diagnostic procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there
is a problem, check to make sure co ...
Mazda 6 Service Manual: Fuel-Filler Lid and Cap
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait for
any hissing to stop, then remove it: Fuel spray is dangerous. Fuel can burn
skin and eyes and cause illness if ingested. Fuel spray is released when there is
pressure in the fuel tank and the fuel-filler cap is re ...