Mazda 6 Service Manual: Rubber parts and tubing

Adjustment

Use suitable gauges and/or testers when making adjustments. ...

Hose clamps

When reinstalling, position the hose clamp in the original location on the hose and squeeze the clamp lightly with large pliers to ensure a good fit. ...

Other materials:

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm inspection
1. Disconnect the negative battery cable. 2. Connect the SST between the ABS (ABS/TCS) HU/CM and harness connector with the ignition switch off. 3. Attach the tester leads to the SST and inspect voltage referring the table below. Terminal Voltage Table (Reference) (Engine is idling, and co ...

Mazda 6 Service Manual: Refrigerant pressure switch inspection
1. Install the SST (gas charging set). 2. Disconnect the refrigerant pressure switch connector. 3. Verify the high-pressure side reading of the SST (manifold gauge) and continuity between the terminals of the refrigerant pressure switch. If not as specified, replace the refrigerant pressure ...