Mazda 6 Owners Manual: Windshield Defrosting and Defogging
1. Set the mode selector dial to the
position.
2. Set the temperature control dial to the desired position.
3. Set the fan control dial to the desired speed.
4. If dehumidified heating is desired, turn on the air conditioner.
WARNING
Do not defog the windshield using the
position with the temperature control
set to the cold position:
Using the
position with the temperature control
set to the cold position is dangerous as it will cause the outside of the windshield
to fog up. Your vision will be hampered, which could lead to a serious accident.
Set the temperature control to the hot or warm position when using the
position.
NOTE
- For maximum defrosting, turn on the air conditioner, set the temperature control dial to the extreme hot position, and turn the fan control dial fully clockwise.
- If warm air is desired at the floor, set the mode selector dial to the
position. - In the
or
position, the air conditioner
is automatically turned on and the outside air position is automatically selected to defrost the windshield. In the
or
position, the outside air position
cannot be changed to the recirculated air position.
Ventilation
1. Set the mode selector dial to the
position.
2. Set the air intake selector to the outside air position (indicator light turns
off).
3. Set the temperature control dial to the desired position ...
Dehumidifying (With air conditioner)
Operate the air conditioner in cool or cold weather to help defog the windshield
and side windows.
1. Set the mode selector dial to the desired position.
2. Set the air intake selector to the outs ...
Other materials:
Mazda 6 Owners Manual: Close Proximity Warning
If your vehicle rapidly closes in on the vehicle ahead because the vehicle applies
the brakes suddenly while you are traveling in headway control, the warning sound
activates and the brake warning is indicated in the display. Always verify the safety
of the surrounding area and depress the bra ...
Mazda 6 Owners Manual: Steering gear and linkage inspection
Rack Inspection
1. Inspect the rack for cracking, damage, and tooth wear. Replace it as
necessary.
2. Measure the runout of the rack.
Runout
Near point A: 0.15 mm {0.006 in} max.
Near point B: 0.20 mm {0.008 in} max.
3. If not within the specification, replace the rack.
Tie-rod End ...