Mazda 6 manuals

Mazda 6 Service Manual: Bonnet removal/installation

Mazda 6 Service Manual / Body / Bonnet / Bonnet removal/installation

Warning

1. Disconnect the windshield washer hose.

2. To remove the bonnet hinge, remove the front fender panel.

3. To remove the bonnet lock, remove the radiator grille.

4. To remove the bonnet release cable, remove the driver-side mud guard.

5. Remove in the order indicated in the table.



6. Install in the reverse order of removal.

7. Adjust the bonnet. (See BONNET ADJUSTMENT.)

Bonnet
...

Bonnet adjustment
Gap Adjustment 1. Remove the front fender. 2. Loosen the bonnet hinge installation bolts and reposition the bonnet. 3. Tighten the bolts. 4. Verify that the gap between the bonnet and the body i ...

Other materials:

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...

Mazda 6 Service Manual: Oil cooler removal/installation
1. Disconnect the negative battery cable. 2. Drain the ATF into a container. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT.) 3. Remove the radiator. (See RADIATOR REMOVAL/INSTALLATION.) 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. 6. Add ATF to ...

© 2016-2026 Copyright www.mazda6info.net