Mazda 6 Owners Manual: Break-In Period
No special break-in is necessary, but a few precautions in the first 1,000 km (600 miles) may add to the performance, economy, and life of the vehicle.
- Do not race the engine.
- Do not maintain one constant speed, either slow or fast, for a long period of time.
- Do not drive constantly at full-throttle or high engine rpm for extended periods of time.
- Avoid unnecessary hard stops.
- Avoid full-throttle starts.
Driving Tips
...
Saving Fuel and Protection of the Environment
How you operate your Mazda determines how far it will travel on a tank of fuel.
Use these suggestions to help save fuel and reduce CO2.
Avoid long warm-ups. Once the engine runs smoothly, begin ...
Other materials:
Mazda 6 Owners Manual: Rear beltline molding removal
Note
When removing the rear beltline molding, the clip may be damaged.
If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B section of the front beltline molding in direction (2), along
the direction (1) shown in the figu ...
Mazda 6 Owners Manual: Wheel hub, hub spindle removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (body side) and fix it to an appropri ...