Mazda 6 Service Manual: Bumper
- Front bumper removal/installation
- Front bumper disassembly/assembly
- Bumper reinforcement removal/installation
- Rear bumper removal/installation
Fuel-filler lid adjustment
1. If not as specified, loosen the fuel-filler lid installation bolts, and
reposition the fuel-filler lid.
2. Measure the gap and height between the fuel-filler lid and the body.
Clearance
a: ...
Front bumper removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Front Bumper Removal Note
1. Pull the front bumper ends (wh ...
Other materials:
Mazda 6 Service Manual: Recommended Tire Inflation Pressure
On the tire label you will find the recommended tire inflation pressure in both
kPa and psi for the tires installed as original equipment on the vehicle. It is
very important that the inflation pressure of the tires on your vehicle is maintained
at the recommended pressure.
You should check t ...
Mazda 6 Service Manual: Jacking positions ,vehicle lift (2 supports),safety stands (rigid rack)
positions
Jacking Positions
Warning
Improperly jacking a vehicle is dangerous. The vehicle can slip
off the jack and cause serious injury. Use only the correct front and rear
jacking points and block the wheels.
Use safety stands to support the vehicle after it has been lifted.
Fro ...