Mazda 6 Service Manual: Camshaft position (cmp) sensor inspection

Mazda 6 Service Manual / Fuel and emission control systems / Control system / Camshaft position (cmp) sensor inspection

Caution

When foreign material such as an iron chip is on the CMP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine control. Be sure there is no foreign material on the CMP sensor when replacing.

Note

Perform the following inspection only when directed.

Resistance Inspection

1. Disconnect the CMP sensor connector.

2. Measure the resistance between CMP sensor terminals A and B using an ohmmeter.

If not as specified, replace the CMP sensor.
If CMP sensor resistance is okay, perform the Circuit Open/Short Inspection.

Specification
400-550 ohms

Circuit Open/Short Inspection

1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)

2. Inspect the following wiring harnesses for open or short. (Continuity check)

Open circuit

If there is no continuity, the circuit is open. Repair or replace the harness.

- CMP sensor terminal A (harness-side) and PCM terminal 2M (harness-side)

- CMP sensor terminal B (harness-siede) and PCM terminal 2J (harness-side)

Short circuit

If there is continuity, the circuit is shorted. Repair or replace the harness.

- CMP sensor terminal A (harness-side) and power supply

- CMP sensor terminal A (harness-side) and body GND

- CMP sensor terminal B (harness-side) and power supply

- CMP sensor terminal B (harness-side) and body GND

Crankshaft position (ckp) sensor removal/installation

Removal 1. Perform the following procedure to making the working space. (1) Remove the Front wheel (RH). (2) Remove the splash shield. 2. Disconnect the CKP sensor connector. 3. Remove the ...

Knock sensor inspection

Note Perform the following test only when directed. Resistance Inspection 1. Turn the ignition switch to LOCK. 2. Disconnect the knock sensor connector. 3. Measure the resistance between the ...

Other materials:

Mazda 6 Service Manual: Transmitter battery inspection
Caution Since the battery voltage does not drop fully if the button is pushed for only 4 seconds or less, it can not be properly examined to see whether it is good or bad. Always push the button for 5 seconds. Note A correct measurement can not be obtained if the battery temperat ...

Mazda 6 Service Manual: Inspection of sst (deployment tool)
Use the SST (Deployment tool) to deploy a live (undeployed) air bag module or pre-tensioner seat belt before disposing of it. Before using the SST (Deployment tool), inspect its operation. Inspection Procedure Follow the steps below to verify that the SST (Deployment tool) is operatin ...