Mazda 6 manuals

Mazda 6 Service Manual: Cigarette lighter inspection

Mazda 6 Service Manual / Body electrical system / Power system / Cigarette lighter inspection

1. Turn the ignition switch to ACC position.

2. Verify that the cigarette lighter comes out within 10-20 seconds

, after pressing the plug into the socket.

Cigarette lighter removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Socket Removal Note 1. Insert a tape-wrapped screwdriver in ...

Relay location
...

Other materials:

Mazda 6 Service Manual: Oil control valve (ocv) removal/installation
L3 1. Disconnect the negative battery cable. 2. Remove the plug hole plate. 3. Remove the high-tension lead. (See HIGH-TENSION LEAD REMOVAL/INSTALLATION.) 4. Remove the oil control valve (OCV) connector. 5. Remove the ventilation hose. 6. Remove the cylinder head cover. (See Cylinder Head Co ...

Mazda 6 Service Manual: Dual proportioning valve inspection (without abs)
1. Connect the SSTs to the brake pipes as shown in the figure. 2. Bleed the air from the brake system. 3. Measure the fluid pressure of the master cylinder and the rear brake. If not within the specification, replace the dual proportioning valve. Fluid pressure ...

© 2016-2026 Copyright www.mazda6info.net