Mazda 6 manuals

Mazda 6 Service Manual: Initial setting

Note

- The battery has been disconnected during vehicle maintenance or for other reasons.

- The power window main switch connector, or driver-side power window motor connector has been disconnected.

1. Turn the ignition switch to the ON position.

2. Press the driver side power window main switch and fully open the driver side window.

3. Pull up the driver side power window main switch to manual-up position to fully close the driver side window, and keep holding the switch up at the position for about 2 seconds

to complete initial setting.

Power window system
...

Two-step down function operative/non-operative switching procedure
Note By following the procedure below, the two-step down function is switched to non-operative when it is operative, and to operative when it is non-operative. ...

Other materials:

Mazda 6 Service Manual: Hold switch inspection
Operating Inspection 1. Turn the ignition switch to ON (engine OFF). 2. Verify that the HOLD indicator light is not illuminated. Depress the HOLD switch and verify that the HOLD indicator light illuminates. If not as specified, inspect the terminal voltage of the HOLD switch. Voltage Insp ...

Mazda 6 Service Manual: Control valve body installation
On-Vehicle Installation Caution Be sure to align the parking rod and the manual valve. 1. Install the accumulator springs and accumulators into the transaxle case. 2. Install the control valve body component. Tightening torque 7.8-10.8 N·m {80-110 kgf·cm, 70-95 in·lbf} Bo ...

© 2016-2026 Copyright www.mazda6info.net