Mazda 6 Service Manual: Power window system
- Initial setting
- Two-step down function operative/non-operative switching procedure
- Door glass position change procedure
- Power window switch removal/installation
- Power window main switch inspection
- Power window subswitch inspection
- Power window regulator removal/installation
- Power window motor removal/installation
- Power window motor inspection
Regulator handle installation
1. Install the clip in the regulator handle.
2. Close the door glass fully and push the regulator handle on as shown. ...
Initial setting
Note
A driver side window will not fully close automatically under
following the conditions:
- The battery has been disconnected during vehicle maintenance or
for other reasons.
- Th ...
Other materials:
Mazda 6 Service Manual: Transaxle range (tr) switch inspection
Operating Inspection
1. Verify that the starter operates only when the ignition switch is at the
START position with the selector lever in P or N position.
If not as specified, adjust the TR switch.
2. Verify that the back-up lights illuminate when shifted to R position with
the ignition ...
Mazda 6 Service Manual: No.7 abs warning light stays on more than 4 seconds with ignition switch on
Diagnostic procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there is a
problem, check to make sure conne ...