Mazda 6 manuals

Mazda 6 Service Manual: Door glass position change procedure

Mazda 6 Service Manual / Body / Power window system / Door glass position change procedure

Note


Two-step down function operative/non-operative switching procedure
Note By following the procedure below, the two-step down function is switched to non-operative when it is operative, and to operative when it is non-operative. ...

Power window switch removal/installation
1. Disconnect the negative battery cable. 2. Remove the front door trim or rear door trim. 3. Remove the screws, then the power window switch. 4. Install in the reverse order of removal. ...

Other materials:

Mazda 6 Service Manual: Power steering oil pump disassembly/assembly
Note The following procedure is for replacement of the O-ring and oil seal only. Replace the pump component if other repairs are necessary. 1. Disassemble in the order indicated in the table. 2. Assemble in the reverse order of disassembly. Power Steering Oil Pump Component Disassemb ...

Mazda 6 Service Manual: On-board diagnostic test
DTCs Reading Procedure 1. Perform the necessary vehicle preparation and visual inspection. 2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure. 3. Retrieve DTCs by WDS or equivalent. Pending Trouble Code Access Procedure 1. Perform the necessary ...

© 2016-2026 Copyright www.mazda6info.net