Mazda 6 Service Manual: Power window subswitch inspection
1. Inspect for continuity between the power window subswitch terminals.
- If not as specified, replace the power window subswitch.
Power window main switch inspection
Drivers side
1. Remove the driver-side front door trim.
2. Connect the power window main switch connector.
3. Measure the voltage at the power window main switch terminals as indicated
below.
4. ...
Power window regulator removal/installation
1. Disconnect the negative battery cable.
2. Remove the front door glass/rear door glass.
3. Remove the front door speaker/rear door speaker.
4. Remove the power window motor.
5. Remove the nuts.
...
Other materials:
Mazda 6 Service Manual: Headlight leveling switch removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Headlight Leveling Switch Removal Note
1. Insert your hand from the lower side of the dashboard and squeeze the tabs
of the headlight leveling switch.
2. Pu ...
Mazda 6 Service Manual: Front crossmember removal/installation
1. Remove the under cover.
2. Remove the splash shield.
3. Remove the front auto leveling sensor. (See FRONT AUTO LEVELING SENSOR
REMOVAL/INSTALLATION.)
4. Remove the transverse member. (See TRANSVERSE MEMBER
REMOVAL/INSTALLATION.)
5. Remove the steering gear and linkage, and pipe assembly i ...