Mazda 6 Owners Manual: Cleaning the Window Interiors
CAUTION
- Do not scrape or scratch the inside of the window glass. It could damage the thermal filaments and the antenna lines.
- When washing the inside of the window glass, use a soft cloth dampened
in lukewarm water, gently wiping the thermal filaments and the antenna lines.
Use of glass cleaning products could damage the thermal filaments and the antenna lines.
Panel Maintenance
If a panel becomes soiled, wipe it off with a soft cloth soaked in clean water
and thoroughly wrung out.
If some areas require further cleaning, use the following procedure:
1. Wipe the soiled are ...
Cleaning the Floor Mats
Rubber floor mats should be cleaned with mild soap and water only.
WARNING
Do not use rubber cleaners, such as tire cleaner or tire shine, when cleaning
rubber floor mats: Cleaning the rubber floo ...
Other materials:
Mazda 6 Owners Manual: Rear beltline molding removal
Note
When removing the rear beltline molding, the clip may be damaged.
If the clip is damaged, replace it with a new one.
1. Pull the A section upward and remove the clip.
2. Rotate the B section of the front beltline molding in direction (2), along
the direction (1) shown in the figu ...
Mazda 6 Owners Manual: Dsc hu/cm inspection
1. Remove the battery and battery bracket.
2. Disconnect the DSC HU/CM connector.
3. Connect the SST (49 G066 004) to the DSC HU/CM connector and
harness side connector.
4. Inspect voltage referring the table below.
Terminal Voltage Table (reference value)
(Ignition switch is at ON, and conne ...