Mazda 6 Service Manual: Dtc 05:er10

Dtc 03:er10

Dtc 06:er10

Other materials:

Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection Note Perform the following inspection only when directed. 1. Warm up the engine and run it at idle. 2. Disconnect the HO2S connector. 3. Connect the voltmeter test leads to the following HO2S terminals: HO2S (front and rear) - (+) leadterminal A - (-) le ...

Mazda 6 Service Manual: Ignition switch inspection
1. Disconnect the negative battery cable. 2. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION) 3. Disconnect the ignition switch connectors. 4. Inspect for continuity between the ignition switch terminals using an ohmmeter. If not as specified, replace the ignition switch. ...