Mazda 6 Service Manual: Dtc c1414

Dtc c1280, c1730, c1951, c1952, c1959

Caution When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used. Diagnostic procedure ...

Dtc c1507, c1508

Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Oil pressure switch removal/installation
Warning When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait untill they are cool before replacing ATF. 1. Disconnect the negative battery cable. 2. Remove the under cover. 3. Disconnect the cord assembly connector. 4. Remove the oil pressure switch. ...

Mazda 6 Service Manual: Rear beltline molding removal
Note When removing the rear beltline molding, the clip may be damaged. If the clip is damaged, replace it with a new one. 1. Pull the A section upward and remove the clip. 2. Rotate the B section of the front beltline molding in direction (2), along the direction (1) shown in the figu ...