Mazda 6 manuals

Mazda 6 Service Manual: Dtc c1507, c1508


Diagnostic procedure


Dtc c1414
Diagnostic procedure ...

Dtc c1510, c1511, c1512, c1513
Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Abs (abs/tcs) hu/cm system inspection
System Inspection Preparation 1. Verify that the battery is fully charged. With the ignition switch on, verify that the ABS and BRAKE system warning lights goes out after 2.4 seconds. 2. If the lights stays on after 2.4 seconds, the ABS (ABS/TCS) HU/CM detects a failure. Follow the troubles ...

Mazda 6 Service Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...

© 2016-2026 Copyright www.mazda6info.net