Mazda 6 Service Manual: Electrical parts
Battery cable
- Before disconnecting connectors or removing electrical parts, disconnect the negative battery cable.
Wiring Harness
- To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver.
Connectors
Data link connector
Insert the probe into the terminal when connecting a jumper wire to the
data link connector.
Caution
Inserting a jumper wire probe into the data link connector
ter ...
Other materials:
Mazda 6 Service Manual: Engine coolant temperature (ect) sensor removal/installation
Warning
When the engine is hot, it can badly burn. Turn off the engine and
wait until it is cool before removing the ECT sensor.
1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
2. Disconnect the ECT sensor connector.
3. Remove the ECT sensor.
4. Install in the reve ...
Mazda 6 Service Manual: Combine sensor removal/installation
Caution
Be careful and do not allow the combine sensor to fall. If by
chance it is subjected to strong impact, replace it.
1. Remove the center console.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. After installation, perform the comb ...