Mazda 6 Owners Manual: Engine Coolant

Inspecting Engine Oil Level

1. Be sure the vehicle is on a level surface. 2. Warm up the engine to normal operating temperature. 3. Turn it off and wait at least 5 minutes for the oil to return to the oil pan. 4. Pull out the ...

Inspecting Coolant Level

WARNING Do not use a match or live flame in the engine compartment. DO NOT ADD COOLANT WHEN THE ENGINE IS HOT: A hot engine is dangerous. If the engine has been running, parts of the engine compa ...

Other materials:

Mazda 6 Owners Manual: Pcm removal/installation
Note For replace the PCM, Setup the WDS and perform the PCM configuration. (See PCM CONFIGURATION.) 1. Disconnect the negative battery cable. 2. For R.H.D, perform the following procedures. (1) Remove the front side trim (left-side). (2) Partially peel back the flower covering. 3 ...

Mazda 6 Owners Manual: Coil removal/installation
Note Do not remove the coil unless you are replacing it. When only the coil is replaced, the immobilizer system reprogram procedure is not necessary. 1. Disconnect the negative battery cable. 2. Remove the column cover. 3. Remove in the order indicated in the table. 4. Install in ...