Mazda 6 Service Manual: Foreword
Outline
- There are two on-board diagnostic functions: Operation mode, which inspects for and indicates correct operation of the input signals to the control module, and condition detection mode, which indicates troubles in the system.
- The two functions can be done using either of the following methods:
- Verifying the flashing pattern of the cruise set indicator light in the instrument cluster.
Inspection Order
Inspection of dtcs for operation mode
Note
The cruise set indicator light will illuminate for 3 seconds? when
operation mode is on.
If the cruise set indicator light does not illuminate for 3
seconds (Operation mode is not on) ...
Other materials:
Mazda 6 Service Manual: Water pump
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) (See
ENGINE COOLANT REPLACEMENT.)
3. Loosen the water pump pulley bolt to remove the drive belt. (See DRIVE
BELT REPLACEMENT.)
4. Remove in the order indicated in the table.
5. Insta ...
Mazda 6 Service Manual: Essential Information
Introduction
Be careful not to hurt yourself when inspecting your vehicle, replacing a tire,
or doing some kind of maintenance such as car washing.
In particular, wear thick work gloves such as cotton gloves when touching areas
that are difficult to see while inspecting or working on your vehi ...