Mazda 6 manuals

Mazda 6 Service Manual: Front turn light removal/installation

Mazda 6 Service Manual / Body electrical system / Exterior lighting system / Front turn light removal/installation

1. Disconnect the negative battery cable.

2. Remove in the order indicated in the table.



3. Install in the reverse order of removal.

Parking light bulb removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. ...

Front side turn light removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. ...

Other materials:

Mazda 6 Service Manual: Air mix actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal F or D of the air mix actuator. 2. Verify that the air mix actuator operates as shown below. If not as specified, replace the air mix actuator. e 3. Verify that the resistance between the terminals of the ...

Mazda 6 Service Manual: Rear crossmember removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...

© 2016-2019 Copyright www.mazda6info.net