Mazda 6 Service Manual: Exterior lighting system

Relay inspection

Relay Type Four-terminal Type A 1. Remove the relay. 2. Inspect for continuity between the relay terminals using an ohmmeter. If not as specified, replace the relay. Type B 1. Remove ...

Discharge headlight service warnings

Discharge headlight bulb service warnings To prevent electrical shock when replacing the discharge headlight bulb, dry hands thoroughly, and carry out work in an area out of rain. When the li ...

Other materials:

Mazda 6 Service Manual: Rear shock absorber removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...

Mazda 6 Service Manual: Liftgate side trim removal/installation
1. Remove the liftgate upper trim. 2. Position the strap hanger as shown in the figure. 3. Pull the liftgate side trim toward you, then disengage clips A, pin B and the strap hanger from the body and pin B, hook C, D from the liftgate lower trim. 4. Remove the liftgate side trim. 5. Remo ...