Mazda 6 Service Manual: General procedures
PRECAUTION (CLUTCH)
Clutch Pipe Removal/Installation
Note
- A common reservoir is used for the clutch and brake system fluid.
1. If clutch pipes have been disconnected any time during the procedure, add clutch fluid (brake fluid), bleed the air, and inspect for leakage after the procedure has been completed.
2. Remove the clutch pipe using the SST
(49 0259 770B). Install the clutch pipe using torque wrench SST
combination. (See TORQUE FORMULAS.)
Location index
...
Clutch fluid
...
Other materials:
Mazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2.
2. Set up the WDS (including the vehicle recognition.)
3. Select Module programming.
4. Select Programmable module installation.
5. Select PCM and perform procedures according to directions on the WDS
screen.
Note
If PCM CONFIGURATION is successful, the PCM ...
Mazda 6 Service Manual: No. 2 all on-board diagnostic functions inoperative
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunctions. If there
is a problem, check to make sure connectors, terminals and wir ...