Mazda 6 manuals

Mazda 6 Service Manual: Ignition coil removal/installation

Mazda 6 Service Manual / Engine electrical system / Ignition system / Ignition coil removal/installation

1. Disconnect the negative battery cable.

2. Remove the plug hole plate.



Ignition system
...

Ignition coil inspection
Primary Coil Winding 1. Remove the ignition coil. 2. Measure the resistance between the following lead holes using an ohmmeter. A and B, B and C - If not specified, replace the ignition co ...

Other materials:

Mazda 6 Service Manual: Theft-deterrent control module inspection
1. Remove the theft-deterrent control module without disconnecting the connectors. 2. Measure the voltage at the theft-deterrent control module terminals as indicated below. 3. Disconnect the theft-deterrent control module connector before inspecting for continuity at terminals L, Q, S, T, a ...

Mazda 6 Service Manual: Battery inspection
Battery Inspect the battery in the following procedure. Test load chart Battery positive voltage with load Back-up Current 1. Verify that the engine switch is at OFF and that the key has been removed. 2. Disconnect the negative battery cable. 3. Measure the back-up current between the n ...

© 2016-2026 Copyright www.mazda6info.net