Mazda 6 manuals

Mazda 6 Service Manual: Ignition system

Generator inspection
Generator Warning Light 1. Verify that the battery is fully charged. Charge if necessary. 2. Verify that the drive belt deflection/tension is correct. (See DRIVE BELT INSPECTION.) If not ...

Ignition coil removal/installation
1. Disconnect the negative battery cable. 2. Remove the plug hole plate. ...

Other materials:

Mazda 6 Service Manual: Rear door glass removal/installation
1. Fully down the rear door glass. 2. Remove the rear door trim. 3. Remove the hole cover. 4. Pull up the rear door weatherstrip and remove the screw. 5. Remove the bolt. 6. Remove the glass run channel from the rear door glass guide. 7. Lift the rear door glass to the position where the rea ...

Mazda 6 Service Manual: Compression pressure
COMPRESSION INSPECTION Warning Hot engines and oil can cause severe burns. Be careful not to burn yourself during removal/installation of each component. 1. Verify that the battery is fully charged. Recharge it if necessary. (See BATTERY INSPECTION.) 2. Warm up the engine to the no ...

© 2016-2026 Copyright www.mazda6info.net