Mazda 6 Service Manual: Intake air temperature (iat) sensor inspection
Resistance Inspection
Note
- Perform the following inspection only when directed.
1. Disconnect MAF/IAT sensor.
2. Measure the resistance between the MAF/IAT sensor terminals D and E using an ohmmeter.
- If not as specified, replace the MAF/IAT sensor.
- If the MAF/IAT sensor is okay, but the IAT PID are out of specification, perform the Circuit Open/Short Inspection.
Specification
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harnesses for open or short. (Continuity check)
Open circuit
- If there is no continuity, the circuit is open. Repair or replace the harness.
- MAF/IAT sensor terminal D (harness-side) and PCM terminal 2E (harness-side)
- MAF/IAT sensor terminal E (harness-side) and PCM terminal 2H (harness-side)
Short circuit
- If there is continuity, the circuit is shorted. Repair or replace the harness.
- MAF/IAT sensor terminal E (harness-side) and power supply
- MAF/IAT sensor terminal D (harness-side) and power supply
- MAF/IAT sensor terminal D (harness-side) and body GND
Pcm configuration
1. Connect the WDS to DLC-2.
2. Set up the WDS (including the vehicle recognition.)
3. Select Module programming.
4. Select Programmable module installation.
5. Select PCM and perform procedures ...
Mass air flow (maf) sensor inspection
Voltage Inspection
Note
Perform the following inspection only when directed.
1. Visually inspect for the following on the MAF sensor.
Damage
Cracks
Terminal bends
Terminal rust
...
Other materials:
Mazda 6 Service Manual: Service warnings
Component Disassembly
Disassembling and reassembling the components of the air bag system
can render the system inoperative, which may result in serious injury or
death in the event of an accident. Do not disassemble any air bag system
components.
Wiring Harness Repair
Incorrec ...
Mazda 6 Service Manual: Automatic transaxle fluid (atf) replacement
Warning
When the transaxle and ATF are hot, they can badly burn you. Turn
off the engine and wait until they are cool before changing the ATF.
1. Remove the oil dipstick.
2. Remove the oil drain plug and washer.
3. Drain the ATF into a container.
4. Install a new washer and the drain ...