Mazda 6 Service Manual: Liftgate

Stay damper disposal

Note The gas in the stay damper is colorless, odorless, and non-toxic. 1. Wear protective eye wear. 2. Lay the stay damper flat. 3. Saw through the stay damper body using a hacksaw. 4. All ...

Liftgate removal/installation

Warning Removing the stay damper without supporting the liftgate can be dangerous. The liftgate may fall and injure you. Open the liftgate fully and support it before removing the stay dampe ...

Other materials:

Mazda 6 Service Manual: On-board diagnostic test
DTCs Reading Procedure 1. Perform the necessary vehicle preparation and visual inspection. 2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure. 3. Retrieve DTCs by WDS or equivalent. Pending Trouble Code Access Procedure 1. Perform the necessary ...

Mazda 6 Service Manual: Rear door glass removal/installation
1. Fully down the rear door glass. 2. Remove the rear door trim. 3. Remove the hole cover. 4. Pull up the rear door weatherstrip and remove the screw. 5. Remove the bolt. 6. Remove the glass run channel from the rear door glass guide. 7. Lift the rear door glass to the position where the rea ...