Mazda 6 Service Manual: Location index

Steering system

...

General procedures

Wheels and Tires Removal/Installation The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-1 ...

Other materials:

Mazda 6 Service Manual: Evaporator temperature sensor inspection
1. Turn the AUTO switch on. 2. Set the temperature control at MAX COLD (Turn the left). 3. Turn the A/C switch. 4. Set the RECIRCULATE mode. 5. Close all doors and windows. 6. Wait for 5 minutes. 7. Remove the glove compartment. 8. Disconnect the evaporator temperature sensor. 9. Measure t ...

Mazda 6 Service Manual: Variable air duct (vad) control solenoid valve inspection (l3)
1. Remove the VAD control solenoid valve. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.) 2. Inspect airflow between the ports under the following conditions. If not as specified, replace the VAD control solenoid valve. If as specified, carry out the Circuit Open/Short Inspection. Circ ...