Mazda 6 manuals

Mazda 6 Service Manual: Magnetic clutch inspection

1. Connect battery positive voltage to terminal A of magnetic clutch and ground to A/C compressor body.


2. Verify that the magnetic clutch operates.


Magnetic clutch adjustment
1. Measure the clearance around the entire circumference between the pressure plate and A/C compressor pulley using a thickness gauge. 2. Verify that the clearance is within the specification. ...

Solar radiation sensor removal/installation
1. Disconnect the negative battery cable. 2. Remove the solar radiation sensor from the dashboard using a tape-wrapped flathead screwdriver. 3. Install in the reverse order of removal. ...

Other materials:

Mazda 6 Service Manual: Steering gear and linkage inspection
Rack Inspection 1. Inspect the rack for cracking, damage, and tooth wear. Replace it as necessary. 2. Measure the runout of the rack. Runout Near point A: 0.15 mm {0.006 in} max. Near point B: 0.20 mm {0.008 in} max. 3. If not within the specification, replace the rack. Tie-rod End ...

Mazda 6 Service Manual: Engine tune-up
IGNITION TIMING INSPECTION Note Ignition timing is not adjustable. Ignition timing verification requires WDS or equivalent. 1. Turn off the electrical loads. 2. Warm up the engine as follows. (1) Start the engine. (2) Maintain the engine speed at approx. 3,000 rpm until the cooli ...

© 2016-2026 Copyright www.mazda6info.net