Mazda 6 manuals

Mazda 6 Service Manual: Control system

Refrigerant lines removal/installation
1. Remove the battery. 2. Discharge the refrigerant from the system. (See RECOVERY.) (See CHARGING.) 3. Remove the washer tank. (L.H.D. only) (See WASHER TANK REMOVAL/INSTALLATION.) 4. Remove the ...

Air intake actuator removal/installation
1. Disconnect the negative battery cable. 2. Remove the glove compartment. 3. Remove the car navigation unit. (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION.) 4. Remove in the order indicated in t ...

Other materials:

Mazda 6 Service Manual: Cruise actuator removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Cover Removal Note Unclamp the clips of the heater hoses at the front of the cover. ...

Mazda 6 Service Manual: Seat Belt Extender
If your seat belt is not long enough, even when fully extended, a seat belt extender may be available to you at no charge from your Authorized Mazda Dealer. This extender will be only for you and for the particular vehicle and seat. Even if it plugs into other seat belts, it may not hold in the ...

© 2016-2026 Copyright www.mazda6info.net