Mazda 6 Service Manual: No.14 poor fuel economy
Diagnostic procedure
No.13 knocking/pinging-acceleration/cruise
Diagnostic procedure
...
No.15 emission compliance
Diagnostic procedure
...
Other materials:
Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection
Note
Perform the following inspection only when directed.
1. Warm up the engine and run it at idle.
2. Disconnect the HO2S connector.
3. Connect the voltmeter test leads to the following HO2S terminals:
HO2S (front and rear)
- (+) leadterminal A
- (-) le ...
Mazda 6 Service Manual: Wheel hub, hub spindle removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (body side) and fix it to an appropri ...