
Diagnostic procedure


No.16 high oil consumption/leakage
No.18 cooling system concerns-runs coldMazda 6 Service Manual: Rear oil seal
REAR OIL SEAL REPLACEMENT
1. Remove the flywheel. (MTX) (See CLUTCH UNIT REMOVAL/INSTALLATION)
2. Remove the drive plate. (ATX) (See DRIVE PLATE REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Rear Oil Seal Installation Note
...
Mazda 6 Service Manual: Manifold absolute pressure (map) sensor inspection
Note
Perform the following inspection only when directed.
The following vacuum values are indicated by relative pressure
from the MAP sensor.
1. Connect the SSTs (WDS or equivalent) to the DLC-2.
2. Turn the ignition switch to ON (Engine OFF).
3. Select MAP PID on the SSTs (WDS or equi ...