Mazda 6 Service Manual: No.3 passenger-side air bag cut-off indicator light does not illuminate
Diagnostic Procedure
- When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiring harness are connected correctly and undamaged.
No.2 air bag system warning light is illuminated all the time
Diagnostic Procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact point ...
No.4 passenger-side air bag cut-off indicator light is illuminated all the
time
Diagnostic Procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact point ...
Other materials:
Mazda 6 Service Manual: No.9 noise while operating a/c system
Diagnostic procedure
* : If there is gas leakage, air enters into the A/C system. The desiccant
within the receiver/drier absorbs the moisture from the air and becomes
saturated. If the A/C system is used in this condition, the inside of the A/C
compressor will begin to rust due to this ...
Mazda 6 Service Manual: Fuel injector removal/installation
Caution
Disconnecting/connecting the quick release connector without
cleaning it may possibly cause damage to the fuel pipe and quick release
connector. Always clean the quick release connector joint area before
disconnecting/connecting using a cloth or soft brush, and make sure that it ...