Mazda 6 Service Manual: Oil control valve (ocv)

Variable valve timing actuator removal/installation

L3 Caution Variable valve timing actuator can not be disassembled because it is a precision unit. Note Variable valve timing actuator camshaft sprocket is integrated with the variabl ...

Oil control valve (ocv) removal/installation

L3 1. Disconnect the negative battery cable. 2. Remove the plug hole plate. 3. Remove the high-tension lead. (See HIGH-TENSION LEAD REMOVAL/INSTALLATION.) 4. Remove the oil control valve (OCV) c ...

Other materials:

Mazda 6 Service Manual: No.9 tcs off light stays on more than 4 seconds with ignition switch on
When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and ...

Mazda 6 Service Manual: Front map light removal/installation
1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Front Map Light Removal Note 1. Insert a tape-wrapped flathead screwdriver into the gap between the headliner and the front map light. 2. Push the hooks to ...