Mazda 6 Service Manual: Engine
- Mechanical location index
- Drive belt
- Valve clearance
- Compression pressure
- Timing chain
- Cylinder head gasket
- Front oil seal
- Rear oil seal
- Engine
- Variable valve timing
- Oil control valve (ocv)
Scheduled maintenance
SCHEDULED MAINTENANCE TABLE
For Europe (L.H.D. U.K.)
Chart symbols:
I : Inspect and repair, clean, adjust, or replace if necessary.
(Oil-permeated air cleaner elements cannot be cleaned using the ...
Other materials:
Mazda 6 Service Manual: Variable air duct (vad) control solenoid valve inspection (l3)
1. Remove the VAD control solenoid valve. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
2. Inspect airflow between the ports under the following conditions.
If not as specified, replace the VAD control solenoid valve.
If as specified, carry out the Circuit Open/Short Inspection.
Circ ...
Mazda 6 Service Manual: Theft-deterrent control module inspection
1. Remove the theft-deterrent control module without disconnecting the
connectors.
2. Measure the voltage at the theft-deterrent control module terminals as
indicated below.
3. Disconnect the theft-deterrent control module connector before inspecting
for continuity at terminals L, Q, S, T, a ...